GUVA-S12SD UV Sensor Ultraviolet Ray S12SD Detection Intensity Module

Extend your light-sensing spectrum with this analog UV sensor module. It uses a UV photodiode, which can detect the 240-370nm range of light (which covers UVB and most of UVA spectrum). The signal level from the photodiode is very small, in the nano-ampere level, that is the reason why it has an LM358 op-amp added to the circuit.

The GUVA-S12SD UV Sensor chip is suitable for detecting the UV radiation in sunlight. It can be used in any application where you want to monitor the amount of UV light and is simple to connect to any microcontroller.

The module, with a typical UV detection wavelength of 2400 – 370nm, outputs a calibrated analog voltage which varies with the UV light intensity.

Size Small: 11mm × 27mm

Low power consumption: 2.5V ~ 5V supply voltage, the current working Microampere is level

Good linearity

High sensitivity

High stability

Detection range: 240nm-370Nm

Large angle: degrees 130

Schottky type of photodiode, suitable for photoelectric mode

Application Typical:

Ultraviolet testers

UV watches

outdoor sports equipment

mobile phones

Weight 10 g
Dimensions 5 × 5 × 3 cm

Reviews

There are no reviews yet.

Be the first to review “GUVA-S12SD UV Sensor Ultraviolet Ray S12SD Detection Intensity Module”

Your email address will not be published. Required fields are marked *

Recently Viewed

  • Sensor Tegangan Voltage DC 0-25v Pendeteksi Volt Arduino Raspberry Pi
    Rp3,000
  • Roda Tipis Thin Smart Car Wheel Tyre Rubber 410 Arduino Robot Line
    Rp2,800
  • Modul EZ-USB FX2LP CY7C68013A USB Logic Analyzer Development Board
    Rp102,000
GUVA-S12SD UV Sensor Ultraviolet Ray S12SD Detection Intensity Module
Rp34,000

51 in stock